Instruction Video Coming Soon!

Start: You have an OptoStand, which needs to be moved or prepared for storage

Step 1 (Optional): If you are preparing for storage, locate the thumbscrew securing the magnet bar(s) and loosen slightly. Note that each individual sign will have at least 1 magnet bar, and some signs will have two or more. Each magnet bar must be moved to ensure proper operation of the signs. If you are only relocating the sign to a new position or do not wish to interrupt the sign’s cycle, skip to step 3

Step 2 (Optional): Move the magnet bar perpendicular to the outer black frame, over the sign itself. Fix the magnet bar in place by tightening the thumb screw. If the sign is on, it will turn off when it detects the magnet.

Step 3: Locate and loosen the thumb screws on the two center hinge blocks. Move these blocks off of the black center hinge and tighten the thumbscrews to secure the blocks in place

Step 4: Remove the two screws on the inside of the frame that will hold the center hinge in place

Step 5: Fold the center hinge up into place

Step 6: Insert and tighten the two internal thumbscrews to hold the center hinge in place

Step 7: Fold the two halves of the OptoStand together and hold in an upright position

Step 8: Locate the two latches (one on each side of the OptoStand) and rotate each so that the latch holds the OptoStand closed. Tighten the thumbscrews (two per latch) to hold the latch firmly in place

End: The OptoStand has now been secured and is ready for transport and/or storage!